1.
For best results, re-proof in warm conditions. If in sub freezing
temperatures, it may be necessary to stand tin in hot water to soften
wax." (Instead of standing the tin in hot water to soften it,
use a blow dryer or heat gun to melt the wax until it is nearly liquid
and then apply small amounts before it cools. NOTE: Our new softer
wax formula does not need to be melted.)
2. Brush all
excess dirt from the area to be treated. Wipe clean with a soft cloth
and
cold water. WARNING: Use clean cold water only.
Do not use soap or detergents."
3. Apply wax
generously with a clean cloth. Use light short circular strokes to
work wax well
into the affected areas--usually seams, creases,
and high flex areas."
4. Use a hairdryer to blow dry evenly over application for a real "factory" finish.
Hang garment overnight in a warm place, away from open flame." (The
wax cools and hardens quickly, sometimes leaving a visible smear of cooled
wax on the surface. Blow-drying the fabric after application melts any
excess wax into the fabric, eliminating the tacky surface.)
|
